SSH

There is a doc in intragere, quickly summarized for *NIX environment hereafter.

First, you have to know the IP adresse of your computer. In a terminal, enter

ip a

It should return something like

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
       valid_lft forever preferred_lft forever
    inet6 ::1/128 scope host 
       valid_lft forever preferred_lft forever
2: enp0s25: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP group default qlen 1000
    link/ether 34:64:a9:d1:2c:fb brd ff:ff:ff:ff:ff:ff
    inet 152.77.132.162/24 brd 152.77.132.255 scope global dynamic enp0s25
       valid_lft 28304sec preferred_lft 28304sec
    inet6 fe80::3664:a9ff:fed1:2cfb/64 scope link 
       valid_lft forever preferred_lft forever
3: wlo1: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN group default qlen 1000
    link/ether be:a0:2c:8f:12:ec brd ff:ff:ff:ff:ff:ff

We are looking for the ethernet adresse (namely enp0s5 in this case, but could be eth0 or other): 152.77.132.162 (it should start with 152.77.)

Then, the IGE use a ssh passerelle, so we need to use it each time. For instance, with this config in ~/.ssh/config (replace login by your login):

Host 152.77.132.162
    ProxyCommand nohup ssh login@ssh.ige-grenoble.fr nc -w1 %h %p

Then, to open a ssh connection, in a terminal enter:

ssh login@152.77.132.162